So I swapped out my old cl s trans for a used 69k oddy trans. The swap went well I swapped over all necessary parts to the odyssey trans. But I also ended up swapping over two other parts because I broke one and the other I knew was new. One of those was the tcc solenoid, and the other was the flat plate with a sensor on it Im not quite sure the name of it but it was held in by 4 10mm bolts that's is mounted directly on the face of the trans. I drove it fine for a whole day and the next day (this morning) the d5, cel and /!\ kicked on all at once. The trans stayed in whatever gear I would manually put it in and stay that way from 0-xx mph until I changed the gear and after switching gears it would shift really HARD... The only code I get is P0753. Shift solenoid A. I checked the connector, the resistance of the shift solenoid and it was all good. Is there anything else I could do to check it? I also did a series of trouble shooting through the alldata troubleshooting steps that I will finish tomorrow and that is starting from the d7 PCM to the the number 2 shift solenoid to see if there is a open wire same for the ground as well. Any advice will be greatly appreciated. I checked the fluid withy the car on and the fluid seemed to be fine. It was all fresh from doing the swap. Thanks in advance for everyone's help.
↧