Hi,
I just bought and installed my jtc short shifter, I ran into a couple of problems. The hole in the rod that connects to the front of the shifter was too small to get the jtc bolt through. I had to remove the oem rubber gasket/washer thing to get the jtc bolt through. Is that what I'm suppose to do? Another problem I am having is with the shifter, when shifting it back to neutral, it does not go back to the center is just stays in that position unless i move it there by hand. It does not spring back to the center like my stock shifter did. It is very notchy. I wonder if they sent me the wrong part. please, any advice will help.
Thank you
I just bought and installed my jtc short shifter, I ran into a couple of problems. The hole in the rod that connects to the front of the shifter was too small to get the jtc bolt through. I had to remove the oem rubber gasket/washer thing to get the jtc bolt through. Is that what I'm suppose to do? Another problem I am having is with the shifter, when shifting it back to neutral, it does not go back to the center is just stays in that position unless i move it there by hand. It does not spring back to the center like my stock shifter did. It is very notchy. I wonder if they sent me the wrong part. please, any advice will help.
Thank you