DIY TL window regulator driver rear

Tools needed:
Philip screw driver
10mm socket
10mm wrench(optional)
an 3/8 extension(optional)

Actually I was not going to post this due to its easiness, but my installation was a bit different from some youtube instruction which does not say important tips and hope that it can help diyers..






1.remove the 2 screws and pull it toward arrow



2.disconnect the link



3.disconnect the connector



4. remove the white cover



5. connect the connector again(step 3), lower the regulator and remove
the 2 bolts.(10mm each)..You may want to use the 10mm wrench for the hidden bolt or lower the regulator if you do not have the wrench



6.disconnect the connector again and pull the window up and tape it so the glass does not fall down



7. remove all the bolts, take the regulator out and transfer the red circled bolts to a new regulator before installation.




8. Now this is most important step
you need to connect the 2 connectors from pic 3 and 5 to the new regulator and lower the regulator like the old regulator before putting into the door
.
the installation is reverse
put the regulator into the door, do step 7 first and then step 5.