Bought a TL-S RSB a couple of weeks ago for a minor upgrade that seemed straight forward install. Ran into some issue with the endlink nuts that are seized like f*ck. :ugh:
These are the things I already tried:
- PB blast the nut a couple of days before the install and during the install
- Torch the sucker to heat up the nut about a min or so, didn't want to heat to transfer to the plastic or rubber around the endlinks
I believe the bolt suppose to move that why you need a allen wrench, but my didn't even move. So it must be extremely rusted.
![Click the image to open in full size.]()
Any idea? before I either dremel the nuts off hopefully wont damage the thread or just paid get it done.
These are the things I already tried:
- PB blast the nut a couple of days before the install and during the install
- Torch the sucker to heat up the nut about a min or so, didn't want to heat to transfer to the plastic or rubber around the endlinks
I believe the bolt suppose to move that why you need a allen wrench, but my didn't even move. So it must be extremely rusted.
Any idea? before I either dremel the nuts off hopefully wont damage the thread or just paid get it done.